---
---
| Split Solar Water Heater System |
Typical components: Add components and 1.3 m2 or 3.2 m2 panels as required to fit your roof and heating requirements. Contact local dealer for current stock and prices. · 10 Watt Solar PV Panel to drive PV Direct Solar Circulation Pump · 3.2m2 Panels or 1.3m2 panels Larger 3.2m2 Heat Pipe panels have the lowest cost per square meter (m2) of collector area, must be mounted at an angle from 15 to 75 degrees and work with drain back systems. Smaller 1.3m2 U-tube panels can work in any orientation, including vertical wall-mount, or horizontal, flat on the roof. Smaller panel area is easier to fit in crowded area. To decide on which panel, check the area where the panels are to be mounted.
|
|
Solar Water heater system with tank split from collector tubes Blends in to roof, fully certified, absolute freeze protection. |
|
|
Solar collectors resembling skylights fit on roof of house. A water storage tank possibly with copper heat exchanger is situated in building below. Circulator pump runs when heat can be recovered; expansion tank and safety valves handle temperature variations. Glycol, if desired, ensures 100% secure freeze protection. See split system installation manual to install.
|
|
|
There are many different sizes of water tanks and split system components; most of which are best sourced through your local plumbing store. Seabird Solar concentrates on solar thermal panels, integrated systems and PV circulation pumps. Call your local dealer.
|
